1.Check whether this switch is at the correct position (Boats with no reversing function, switch up to 7:3 position; boats with reversing function, switch down to 5:5 position)
2. Ensure that the throttle reverse switch is at the left position；check whether the throttle trim is centered (you will hear two short "beep" sound when it is centered )
3. If the problem still exist, please follow the steps below to adjust the throttle：
1. Cut off the power of ESC, turn on TX, turn throttle at max position and hold.
2. Connect ESC with battery and wait for 2 short tone to enter program menu. After the tone there will be circulatory primary menus, each menu will beep 4 times before entering next.
3. Release your throttle trigger when you hear the tone of target menu, the system will save your setting.
| Beeping Instruction |
|
Beeping tones： E=beep-- 1 long tone |
| tone 1 | Throttle travelling reset |
|
A-A-A-A |
| tone 2 | Brake on/off | B-B-B-B | |
| tone 3 |
Battery types |
Ni-Mh | C-C-C-C |
| tone 4 |
Battery types |
Lithium |
D-D-D-D |
| tone 5 |
Low voltage protection value |
Low |
E-E-E-E |
| tone 6 |
Low voltage protection value |
Middle |
AA-AA-AA-AA |
| tone 7 |
Low voltage protection value |
High |
BB-BB-BB-BB |
| tone 8 |
Reset to factory data |
CC-CC-CC-CC |
|
| tone 9 |
Angle of advance |
Automatic |
DD-DD-DD-DD |
| tone 10 |
Angle of advance |
Low |
EE-EE-EE-EE |
| tone 11 |
Angle of advance |
High |
AAA-AAA-AAA-AAA |
| tone 12 |
Motor starting power |
Soft |
BBB-BBB-BBB-BBB |
| tone 13 |
Motor starting power |
Intermedia |
CCC-CCC-CCC-CCC |
| tone 14 |
Motor starting power |
Strong |
DDD-DDD-DDD-DDD |
| tone 15 |
Helicopter mode |
Off |
EEE-EEE-EEE-EEE |
| tone 16 |
Helicopter mode |
Mode 1 |
AAAA-AAAA-AAAA-AAAA |
| tone 17 |
Helicopter mode |
Mode 2 |
BBBB-BBBB-BBBB-BBBB |
| tone 18 |
Motor spinning direction |
|
CCCC-CCCC-CCCC-CCCC |
| tone 19 |
PWM motor rates |
8K |
DDDD-DDDD-DDDD-DDDD |
| tone 20 |
PWM motor rates |
16K |
EEEE-EEEE-EEEE-EEEE |
| tone 21 |
LVD protection mode |
Lower throttle |
AD-AD-AD-AD |
| tone 22 |
LVD protection mode |
Cut off power |
AE-AE-AE-AE |
Please find attached video for more detailed instruction.
